Phenol ketone products

Plastic rubber

Current Location： Home > News > Chemical Knowledge > The correct use of sodium ethoxide and precautions

[Chemical Knowledge]：The correct use of sodium ethoxide and precautions

Read： 969 Time：15months ago Source：Transform the World with Simplicity

Sodium ethoxide is a commonly used chemical reagent, which is widely used in laboratory and industrial production. The correct use of sodium ethoxide can not only ensure the accuracy of the experimental results, but also ensure the safety of the operators. Let's learn about the correct use of sodium ethoxide and matters needing attention.

on the storage and preservation of sodium ethoxide. Sodium ethoxide should be stored in a dry, well-ventilated place, away from fire and oxidizing agents. Avoid mixing or contact with acids to avoid toxic gases.

to avoid sodium ethoxide moisture and heat, so as not to affect its chemical properties and use effect. The dosage and concentration of

sodium ethoxide need to be strictly controlled during use. When preparing sodium ethoxide solution, it should be diluted according to the correct proportion according to the specific experimental requirements, so as to avoid the influence of too high or too low concentration on the experimental results. At the same time, be careful when using sodium ethoxide solution to avoid splashing on the skin and eyes, and oral administration is strictly prohibited. Once accidentally contact with skin or eyes, should immediately rinse with plenty of water, and timely medical treatment.

third, the waste disposal of sodium ethoxide also requires special attention. Discarded sodium ethoxide solution shall be classified and packaged in accordance with relevant regulations and be disposed of by specialized units. Do not pour it into the sewer or mix it with other substances to avoid environmental pollution and safety hazards.

laboratory personnel using sodium ethoxide require personal protection. Wear protective goggles, gloves, and a lab coat when using sodium ethoxide to ensure safe handling. After the end of the experiment, the hands and the experimental table should be thoroughly cleaned, and the sodium ethoxide solution splashed on the experimental table should be cleaned in time. The correct use of sodium ethoxide in

requires strict compliance with relevant regulations and standard operating procedures to ensure the safety of laboratory personnel and the accuracy of experimental results. I hope that the introduction of this article can help you better use sodium ethoxide and avoid accidents and unnecessary accidents.

Previous： Note the use of medium pressure furnace, let you more assured to use

Next： Precautions and solutions to common problems in acylation experiments

News Categories