Phenol ketone products

Plastic rubber

Current Location： Home > News > Chemical Knowledge > Edward vacuum pump refueling precautions

[Chemical Knowledge]：Edward vacuum pump refueling precautions

Read： 652 Time：14months ago Source：Transform the World with Simplicity

As a commonly used industrial equipment, Edward vacuum pump is widely used in various fields. In order to ensure the normal operation of the vacuum pump, correct maintenance and refueling are very important. The following is to introduce some of the Edward vacuum pump refueling matters needing attention. It is very important for

to choose the right lubricant. When refueling the vacuum pump, be sure to choose the lubricating oil that meets the standard requirements, and keep the lubricating oil clean and dry. Different types of vacuum pumps may have different requirements for lubricating oil, so be sure to check the instruction manual or consult a professional before refueling.

the correct refueling method is also crucial. Before refueling, first make sure that the vacuum pump has stopped running and cooled to room temperature. Then, follow the instructions in the instruction manual, locate the fuel filler and use the special refueling tool to refuel. In the refueling process, to ensure that the fuel filler around the clean, and to avoid adding too much lubricating oil. The cycle of

refueling also needs attention. In general, the refueling cycle of the vacuum pump depends on the frequency of use and environmental conditions. It is recommended to check the condition of the lubricating oil regularly during use, and add or replace the lubricating oil in time as needed. Vacuum pumps used in hot, humid or dirty environments may have more frequent refueling cycles.

pay attention to the inspection and cleaning after refueling. After refueling is completed, clean up the oil stains around the refueling port in time, and ensure that the sealing performance of the refueling port is good. Then, start the vacuum pump and observe whether the lubricating oil works normally, and pay attention to whether there is abnormal noise or vibration. If an abnormal situation is found, it should be stopped in time and the cause should be found.

In summary, correct refueling and maintenance are essential to the normal operation of the Edward vacuum pump. Choosing the right lubricating oil, the correct refueling method, the reasonable refueling cycle, and the inspection and cleaning work after refueling can not be ignored. It is hoped that the introduction of this article can help users to use and maintain vacuum pump equipment correctly, extend the service life of the equipment and improve production efficiency.

Previous： The correct use of chromium azure method to measure aluminum and matters needing attention

Next： Synthesis of n-butyl benzoate and its precautions

News Categories